In actual use, as a variety of lighting equipment, high pole lights carry the function of illuminating people’s night life. The biggest feature of high mast light is that its working environment will make the surrounding light better, and it can be placed anywhere, even in those tropical rainforests where the wind and sun are blowing, it can still play its role. Their service life is relatively long, and in actual maintenance, the maintenance is not as troublesome as we imagined, and the sealing performance is also good. Today, follow high mast light manufacturer Tianxiang to take a look at the precautions for transportation and installation.
Transportation of high mast lights
1. Prevent the light pole of the high mast light from rubbing against the vehicle during transportation, causing damage to the galvanized layer used for anti-corrosion treatment. Damage to the galvanized layer is a common problem during the transportation of high mast light. When producing and designing high mast light, high mast light manufacturer Tianxiang will carry out anti-corrosion treatment, usually by galvanizing. Therefore, the protection of the galvanized layer during transportation is very important. Don’t underestimate this little galvanized layer. If it is missing, it will not only affect the aesthetics of the high pole lights, but also lead to a significant reduction in the life of the street lights, especially in rainy weather conditions. Therefore, we’d better repack the light pole during transportation, and pay attention to whether it is properly placed when placing it.
2. Pay attention to the damage of the key parts of the tie rod. This happens relatively rarely, but when it does, repairs can become a hassle. It is recommended to repackage the sensitive parts of high mast light without too much trouble.
Installation of high mast lights
1. According to the instruction manual of the high pole light, the operator must stay away from the pole body when operating the manual button box. The operator must stay away from the pole body. Move the lamp panel up until it is about 1 meter away from the top of the pole and hangs freely. Disconnect the triple switch. Connect the waterproof and anti-loosening plugs, test the power supply voltage and phase sequence with a multimeter, insert the plugs accordingly, and then close the high breaking rate air switches one by one. Pay attention to observe whether the lighting sequence of the light sources is consistent with the wiring phase sequence diagram.
2. Break each high breaking rate air switch. Unplug the waterproof and anti-loosening plug. Close the triple switch. Operate the button box, lower the light stand to the light stand bracket, check whether the connection is loose, move and other bad conditions, and correct it if there is any. Fine-tune the levelness of the light stand again.
3. Re-hung the light frame on the suspension device at the upper end of the light pole, reverse the elevator, and loosen the wire rope slightly.
4. After the installation is completed, the customer will accept the project.
The above is the transportation and installation of the high mast light introduced by high mast light manufacturer Tianxiang. If you are interested in high mast light, welcome to contact high mast light manufacturer Tianxiang to read more.
Post time: Apr-27-2023
